Assembly – CLO Systems LVM-601-2 User Manual

Page 4

Advertising
background image

| 4 |

LVM-601.2

MADE IN SWEDEN

Assembly

5.

Fix the central unit and connect the actuator. Con-

nect also the external IR eye and powersupply temporar-

ily. Press the enclosed remote to open the mount fully.

Disconnect and remove the powersupply and IR eye.

6.

Lift up the TV-wallmount package and hang it gently on the screws

in the wall. Align it vertical with the water level and tight the screws.

Remove the locking sprint and washer, fold out

the actuator from the bracket. Mount the addi-

tional screws in the wall. Assembly the actuator

again. Connect all cables for the TV and also the

powersupply and IR eye to the wall mount. Wire

them to the frame with the enclosed cable ties.

Pay attention to that no cables get stuck in the

mechanism when operating. Fasten also the soft

stopper pad as illustrated.

7.

If necessary, use the smart horizontal and vertical adjustments to

align the wall mount in level.

!

Depending on wall

surface IR reflection
factor, the remote re-
ceiver may require clear
sight from IR remote

8.

Carefully adjust the friction brake for smooth

operation. (Normally not necessary).

!

If the TV turns out to be very slanting, or the wallmount does not fully close, you need to adjust

the U-profiles in the TV to approximately horizontal level; First set the horizontal pitch to center,
then lift the TV and gently loose the two outer screws which holds the U-profiles in the TV. Align the
TV horizontal and fasten the screws.

Be careful not to loose the screws to much as it may result in the

TV to fall down! If necessary, fine adjust with the horizontal adjustment on the wall mount.

English

Advertising