CLO Systems LVM-601-2 - Manual (Page 6)

| 6 | LVM-601.2
MADE IN SWEDEN
Operation
Learning
The learnable wallmount receiver is pre-programmed to operate with the late edition of Lava
Chameleon and Khor series remote controls. If you do not have such TV, please use the en-
closed remote (which also can be used to operate the most common functions on the above
mentiond Lava models). You can also learn the receiver to operate from one of your existing
remotes, for example your TV control. Here is how you do:
1. Flip the switch to ”Learn Motor 1” mode.
2. Press and hold for 2 sec the button on your remote that you want to use for out operation.
3. Release the button, and led flashes red.
4. Press and hold the same button again for 2 sec.
5. Release the button, and the led is green.
6. Press and hold for 2 sec the button on your remote that you want to use for in operation.
7. Release the button, and led flashes green.
8. Press and hold the same button again for 2 sec.
9. Release, and the led turns off.
10. Learning completed, flip the switch back to ”Operate Mode” and you can start to use.
!
Even though
this decvice is
designed to handle
most of the remote
formats on the
market, some may
not work. In this
case try another
one, or use the
enclosed remote.
Note! It is neccessary that you wait for at least 1
sec. between pressing the keys when programming.
The central unit has beside learning and operate mode
also a ”Lock” function which if it is switched on, disables
all functions. This can be used in public places or to
prevent children from using the device
English
Specifications
Operation Voltage: 100-240VAC, Secondary 12VDC 2A
Max weight on TV at wall installation 50kg
Max weight on TV at ceiling installation: 13kg. This can be increased if the powersupply is replaced. Contact your dealer.
Dimensions on TV at wall installation: Width: 700-1300mm Height: 430-∞mm
Dimensions on TV at ceiling installation: Width: 420-∞mm Height: 400-470mm
Fits wall mount screw location on TV: Width: 50-668mm Height: 50-400mm
* For illustration of details, look at the rear of this User manual.
Using
The in and out function have a 1sec delay in order to avoid any accidental use. Press and
hold the button on your remote, and the wall mount starts to move after 1sec. Release the
button, and the mount stops and locks in that position.