Crane Song AVOCET II - Manual (Page 34)

ACCESSORY CONNECTOR
1 Right Channel Source Output
2 gnd
3 gnd
4 talk mic output - When talk button is pushed (Mic Output)
5 Right phones out (Line level phone bus)
6 Left phones out (Line level phone bus)
7 gnd / ground
8 data I/O do not connect
9 gnd
10 gnd
11 gnd
12
Surround mono input 6
13 Surround mono input 5
14 Left Channel Source Output
15 mono out
16 talk command in - enable by tying to gnd
17 mute+
18 mute-, solo-
19 solo+
20 used in surround wiring from left-right to center channel
21 gnd
22 Surround mono input 1
23 Surround mono input 2
24 Surround mono input 3
25 Surround mono input 4
To use the external mute or solo inputs 5 to 15 volts needs to be applied to the control
input lines. Polarity must be followed. These inputs are optical isolated.
The mute control is push on - push off, the talk input is also push on - push off
or latching. The solo switching remains in the soloed state as long as the control volt-
age is applied. A jumper is provided on the main pcb that selects either the solo is the
DAW or ANA1 input as the solo input.
All audio signals are unbalanced
Starting with the rev5 pcb the low connection for mute and solo has changed
See the section on headphone setup and the external wiring connections.
34