Cisco WEC600N - Manual (Page 18)

Chapter 3
Configuration
17 Dual-Band Wireless-N ExpressCard
On the Adapter’s PIN number screen, click 3. Next.
Enter the PIN Number
The Adapter connects to the network. 4.
Connecting to the Network
Click 5. Print to print out your wireless network settings.
Then click Finish to return to the Status screen, or click
Exit to exit the Monitor.
Congratulations
Congratulations! The Adapter is connected to the network.
Enter Key Manually
Proceed to the appropriate section, “Wireless Security
Disabled” or “Wireless Security Enabled”.
Wireless Security Disabled
If you connect to a network whose wireless security is
disabled, then you will view this screen:
Click Connect Anyway
Click 1. Connect Anyway.
Click 2. Finish.
Congratulations
Congratulations! The Adapter is connected to
the network.
Wireless Security Enabled
If you connect to a network whose wireless security is
enabled, then you will view one of three screens.
Proceed to the appropriate instructions. 1.
WPA2 (Wi-Fi Protected Access 2)
If the network uses WPA2 Personal security, then
the WPA2-Personal Key Needed for Connection screen
appears.