Crown Verity Gas Grill - Manual (Page 2)

24 Wildwood Drive, Essex Junction, Vermont 05452 Phone: (802)878-6190 Fax: (802)878-6190
Website: www.crownverity.com Email: [email protected]
CLEANING AFTER USE:
1. Ensure all gas control knobs are in the off position.
2. Turn off gas valves on propane tanks or shut valve on natural gas line.
3. Empty water pans of water and debris. Be careful as these pans will remain hot
for some time after the unit has been turned off.
4. Thoroughly clean unit using soap and water to begin with. Dawn detergent is a
good liquid soap to use. The water pans can be filled with soap and water and
the cooking grids can be placed inside of the water pans to let them soak.
5. After removing the primary debris the unit should be cleaned with a degreaser.
The Crown Verity BBQ cleaner works best and is designed to be used when the
unit is cool and dry. More than one application may be required to thoroughly
clean the unit.
6. The hoods of the unit will slide off the unit by lifting the two pins located on the
back lip of the cooking grid on each side of the unit and sliding the hoods
backwards. This will make it easier to access various areas of the grill for
cleaning.
7. After degreasing the unit, clean again with soap and water. The unit can be
cleaned with a pressure washer – just be careful not to spray water up into the
burners from the underside of the unit - spray from the top down.
8. Ensure everything is put back in its proper position. Cooking grids, hoods and
aligning pins, and water pans.