COBY MP-C353 - Manual (Page 5)

Page  Coby Electronics Corporation www.cobyusa.com Page 
Grounding or Polarization: This product may be equipped with a
polarized alternating-current line plug that has one blade wider than
the other. This plug will only fit into the power outlet in one direction.
This is a safety feature. If you are unable to insert the plug fully into
the outlet, try reversing the direction of the plug. If the plug should still
fail to fit, contact an electrician to replace the obsolete outlet. Do not
defeat the safety purpose of the polarized plug.
Power-Cord Protection: Power supply cords should be routed so
that they are not likely to be walked on or pinched by items placed
upon or against them, paying particular attention to cords at plugs,
convenience receptacles, and at the point which they exit from the
product.
Protective Attachment Plug: The product may be equipped with an
attachment plug with overload protection. This is a safety feature. See
the operating instructions for replacement or directions to reset the
protective device. If replacement of the plug is required, be sure the
service technician has used a replacement plug that has the same
overload protection as the original plug as specified by the manufac-
turer.
Outdoor Antenna Grounding: If an outside antenna is connected to
the product, be sure the antenna system is grounded so as to provide
some protection against voltage surges and built-up static charges.
Article 810 of the National Electrical Code, ANS/NFPA 70 provides
information with regard to proper grounding of the mast and support-
ing structure, grounding of the lead-in wire to an antenna-discharge
unit, size of grounding conductors, location of antenna-discharge unit,
connection to grounding electrodes, and requirements for the ground-
ing electrode (see figure).
12.
13.
14.
15.
IMPORTANT SAFETY INSTRUCTIONS