Dynaflite DYFA3030 User Manual
Page 13
13
❏ ❏
30. Fit and glue the laminated WT1 to the
center of rib W5 and in the notches of W6 and
WTR1.
❏ ❏
31. Fit and glue one of the rear wing tip
pieces WT2 and WT3 that you glued together in
step 28 to the bottom of ribs W5, W6, WTR2, and
to the bottom lamination of WT1.
❏ ❏
32. Fit and glue the top rear wing tip pieces
WT2 and WT3 in place. Pinch them together along
the outside edge.
❏ ❏
33. From a 3/32" x 3/8" x 30" balsa stick,
cut, fit and glue the cap strips to rib W6 and WTR1
between ribs W5 and W6.
❏ ❏
34. Unpin the wing from the building board.
Cut slots 1/16" wide in front of and behind the
spars in rib W1. Being careful not to damage the
sheeting, make a 1/16" wide slot in front of the
spars in rib W2.
❏ ❏
35. Sand the spars, LE, TE and sheeting flush
with root rib W1.