Dynaflite DYFA3030 - Manual (Page 19)

19
earlier, glue formers F4, F5, F6 and F7 into place.
Check to insure that the fuselage remains straight
and square.
❏
16. Note the angle of the instrument panel on
the plan and glue it into place.
❏
17. Use the 3/32" x 3" x 36" balsa sheet to
sheet across the fuselage bottom from the wing
saddle to the tail. Sheet around the tail wheel
bracket as shown in the photo. Trim the sheeting
flush with the sides of the fuselage.
❏
18. Using the remainder of the 1/4" x 3/8" x
36" balsa stick, glue the top stringer between F1, F2
and the instrument panel. Sand it flush with the front
of F1 and the rear of the instrument panel.
❏
19. Glue the 1/4" x 3/8" top stringer between
F3 and F5A, sanding it flush with the front of F3.
❏
20. Now is a good time to install the control
pushrods of your choice.
❏
21. Using the 1/8" x 3" x 24" balsa sheets, sheet
the front top of the fuselage as shown in the photo.
NOTE : You can trim the cockpit opening now or at
step 23.
❏
22. Sheet the top of the fuselage rear from the
center of the cockpit to F5A.
❏
23. Trim the sheeting flush with F1 and F5A. Use
the cockpit cutout pattern on the plan to cut the
cockpit opening.
❏
24. Glue the 1/8" x 1/4" basswood stringers
into position between F5 and F7.
❏
25. Glue the 1/4" x 1" x 4" ply wing mount blocks
into place, one on each side of the fuselage, with