DVIGear DVI-3120a - Manual (Page 9)

-7-
5.1.4 Menu Ranges and Defaults
The adjustment range and factory preset value as follows:
Value Range Default Value
Contrast
Bright
Color 0~255
0~255
0~255 047
102
064
Note: Select reset to reset all adjustment back to the factory preset value.
HV adjust - When selected, the following sub-menu appears.
H-position 64
V-position 42
Use the + and – buttons to adjust the best horizontal and vertical position of the picture.
OSD adjust – When this mode is selected, you can adjust the Horizontal and
Vertical position of the OSD menu.
System information – When selected, this shows the input/output resolutions and
their vertical refresh rate on the screen.
Auto adjust – When selected, the DVI-3120a will automatically adjust all the
parameters to the factory presets.
Exit – Select to exit from the current menu page.
Notes:
• The default output resolution of the DVI-3120a is XGA@60 Hz.
• The unit has non-volatile memory and memorizes all your setting before
power off and recalls those setting on next Power ON; however, changing
output resolution erases all settings.
• At any time, pressing + and - buttons simultaneously will reset the output
resolution to XGA@60Hz, and other settings back to factory default values.
6.0 TROUBLESHOOTING
Other than checking for faulty cables, the only common problem would be choosing
a wrong Input or Output Setting. Make sure the display is capable of handling the
resolution and refresh rate selected. Also be sure to use the correct type of cable
for the output format selected (RGB or YPbPr).
After trying the above suggestions, should the problem still persist, contact your
dealer for additional suggestions. Should the dealer’s technical personnel be
unable to assist you, please contact DVIGear via telephone at (888) 463-9927
(United States and Canada); international callers may dial (770) 421-6699, or
through e-mail at [email protected].