Eagle Microsystems LP4310 - Manual (Page 3)

LP4310 IB.DOC
9/16/04
Fig. 1: LP4310
The LP4310 was designed for easy installation and maintenance. All maintenance and calibration work is
performed from the top surface and does not require the removal of any decking or lifting the scale to
adjust the leveling
SECTION 2.0 PREPARATION FOR USE
2.1 RECEIVING INSPECTION
1. Upon receiving the scale, carefully inspect the condition of the crate including the banding
and any protective covering used for shipping. Report any damage to the shipper and to
Eagle Microsystems.
2. Remove the scale from crating and inspect for damage. Report any damage to the shipper
and to Eagle Microsystems.
3. The scale is shipped with one (1) leveling feet removed. The leveling foot is packaged and
Strapped to the cable. Keep this with the scale untill instllation time.
2.2 SHIPMENT
Should re-shipment of your scale become necessary.
1. Use a strong, well built crate. The crate must be larger than the outer dimensions of the
scale to protect it in shipping.
2. Make sure the hook-up cable is protected and secured in crate.
4. Use strong banding to secure scale in shipment.
2.3 SITE SELECTION
1. Line power devices causing large inductive currents should not run off the same circuit as
the scale. Fluctuations in line voltage caused by such devices may result in display instability.