ebm-papst A3G800-AN36-23 - Manual (Page 8)

Operating instructions A3G800-AN36-23
Translation of the original operating instructions
Fig. 2: Connecting the wires to terminals
; Seal the terminal box.
4.3.3 Cable routing
No water may penetrate along the cable in the direction of the cable gland.
Fans installed lying flat
Make sure that the cable is routed in the form of a loop (water trap).
Fig. 3: Fan installed lying flat, cable routed as a water trap.
Fans installed in upright position
When routing the cable, ensure that the screwed cable glands are
arranged at the bottom. The cables must always be routed downwards.
Fig. 4: Cable routing for fans installed upright.
4.4 Factory settings
Factory settings with which the device is pre-set by ebm-papst.
Operation mode PWM controlling
Group adress 1
Fan / device adress 1
Max. PWM / % 100
Min. PWM / % 0
Save set value to
EEPROM No
Set value control Analog
Control function Positive (heating)
Item no. 50443-5-9970 · ENG · Revision 84593 · Release 2015-01-05 · Page 8 / 12
ebm-papst Mulfingen GmbH & Co. KG · Bachmühle 2 · D-74673 Mulfingen · Phone +49 (0) 7938 81-0 · Fax +49 (0) 7938 81-110 · [email protected] · www.ebmpapst.com