Ecler WPTOUCH - Manual (Page 11)

11
1. From USER mode, press KEY 2 and, without releasing,
press KEY 1. Keep both keys pressed for 3 seconds.
2. On the screen, line 1 will display "EDIT SOURCE NAME"
and line 2 will display the name of the active selection.
3. Release KEY 1, holding KEY 2.
4. Press again KEY 1.
5. On the screen, line 1 will display "EDIT DEVICE NAME"
and line 2 will display the name assigned to the device.
6. Release again KEY 1, holding KEY 2.
7. Press again KEY 1. The first parameter of the previous
list will be displayed on screen.
8. Release KEY 1 then KEY 2. In this status, the wheel has
two operating modes:
•
as left/right navigation keys (clicking on the
positions corresponding at 9 and 3 in the face of a
clock), to select the previous or next available
parameter.
•
usual rotating mode, to change the selected
parameter value.
9. Once the changes are made press KEY 2 to validate. The
message "..." is temporarily displayed in line 2 of the
screen then the previous display returns, showing the last
modified parameter and its new value. If you want to
cancel the parameter editing without leaving
CONFIGURATION Mode, you must select a new
parameter in the list (item 7), since selecting a new
parameter cancels the changes you didn’t validate with
KEY 2. If, however, you want to leave CONFIGURATION
Mode and return to USER mode, press KEY 1.
In CONFIGURATION mode and after 20 seconds since the
last action, non-validated changes would be discarded, and the panel
automatically returns to USER mode.
4.3. Infrared Control
The WPTOUCH features an IR receiver compatible with the
optional REVO-IR remote control. The control of VOL UP/VOL DOWN
functions and the function assigned to KEY 1 (MUTE in analogue mode
and a programmable function in digital mode) are compatible with IR codes
sent from the REVO-IR, so it’s possible to use the REVO-IR to manage
these functions at a distance of the WPTOUCH. The LCD display
illumination flashes when the unit receives and accepts IR pulses emitted
by the REVO-IR.