Ecler WPTOUCH - Manual (Page 6)

6
4. OPERATION
4.1. WPTOUCH Operating Modes
After resetting the device (reset) or at startup, the WPTOUCH
will be in analogue mode (ANALOG). If connected to a MIMO88 via its
digital bus, this connection will be established, synchronized, and the digital
mode will be automatically recalled (DIGITAL LOCKED, the icon of
connection appears in LCD display).
Once in digital mode, and if communication is lost between the
devices, the WPTOUCH remains in offline mode (UNLOCKED) until a new
synchronization with MIMO88. If you want to return to analogue mode from
the offline mode, you have to reset the device in order to come back to the
initial stage.
In digital mode, the device can be disabled to prevent unwanted
tampering (DISABLED).
The following diagram illustrates the different WPTOUCH status
and possible transitions between them:
In analogue mode, the functions of the wall panel touch
controls are:
•
KEY 1 (left): MUTE ON / OFF. When the MUTE function is
activated (MUTE ON), the volume indicator is replaced on the
second line of the display by the word "MUTE" and an asterisk
appears on the far left of the display. At the same time, the DC
control voltage is modified so that it mutes the device
connected to the WPTOUCH through the analogue remote
control port for DC control voltage.
•
KEY 2 (right): source selection, among the maximum number of
selections defined in the CONFIGURATION menu (see below).
The sequence to follow for the source selection is:
1. Press KEY 2: If the panel is set to display the device
name on the first line of the screen, the name of the
active selection will temporarily be displayed instead. The
arrow on the far right of the display indicating the
parameter the wheel is controlling will jump from the
second to the first line of the display.