Ecler AmicLab - Manual (Page 4)

4
1. IMPORTANT NOTE
Congratulations! You are the owner of a carefully designed and manufactured equipment. We
thank you for your confidence in choosing our .amic digital processor card.
In order to get maximum performance from all your card functionalities, it is VERY IMPORTANT
to carefully read and follow these instructions before any connection.
For an optimum operation maintenance has to be done by our Technical Services.
1.1. Cleaning
Never use solvent or benzene based or abrasive cleaning material on the control panel, to avoid
the possibility of paint or silk printing damage. For cleaning, use a soft cloth slightly dampened with
water and mild detergent. Never use sharp or erosive objects to scratch the control panel.
2. INSTALLATION
1. Unplug the amplifier.
2. Unscrew and remove amplifier's cover and back plate.
3. Remove the two jumpers from the input stage connector. Keep the jumpers and the back plate in safe
place. You'll need them to use the amplifier without the filter.
4. Insert the filter in its back panel location and plug its cable (see diagram).
5. Screw the filter and the cover.
CAUTION: Filter installation must be done by a qualified technician.
3. INTRODUCTION
3.1. About .amic
.amic is an extension card for ECLER DPA line of amplifiers. Extension cards add new features
to amplifiers, e.g. crossovers, parametric filters, limiters...
.amic card specially has a powerful and fully programmable digital signal processor with two high
quality audio input channels and four output ones as well as a USB computer link. Additionally, .amic
offers two external connections for remote volume control.
NOTE: A maximum of 16 inputs in parallel can be connected to the same control potentiometer. All
amplifiers ground must be linked.