EcoTech Marine MP60wES - Manual (Page 4)

Installing the VorTech
™
STEP 1: Choose Pump Location
•
Where the pump output is unobstructed
• High enough above the sand bed so sand is not disturbed
• Sufficiently below the surface so air is not sucked
into a vortex
STEP 2: Prepare Aquarium
•
Use an aquarium scraper to clean the inside surface of
the aquarium and a damp cloth to clean the outside.
• Use caution when handling an aquarium scraper.
STEP 3: Attach Hanger and Mounting Tab
• Peel backing from the mounting tab and place the tab
on the outside of the aquarium (Figure B).
4 5
SET UP YOUR
MP60
WATCH THE VIDEO:
ecote.ch/mp60setup
A B
C
E F
STEP 5: Place Dry Side on Aquarium
• Hook the thickness spacer to the hanger (Figure E)
• Tie cord to mounting tab using a zip tie (Figure F).
Trim the exces end of the zip tie.
STEP 4: Prepare Dry Side
• Determine the glass thickness by measuring
it or contacting the aquarium manufacturer, and
Never place the dry side in the aquarium.
Failure to use the rubber spacer can damage the
pump, which will NOT be covered under warranty.
choose the appropriate thickness spacer.
• Remove all stickers and wax paper from motor
assembly, revealing the adhesive (Figure C).
• Hold Dry Side with the power cord pointing up,
and align the hook on the thickness spacer with
the power cord. Firmly press thickness spacer
against the Dry Side to attach them (Figure D).
• Peel backing from the hanger and place directly
above the desired mounting location on the outside
of the aquarium (Figure A).
a few inches above the desired mounting location
D
a few inches above the desired mounting location