EcoTech Marine Gen 2 MP40 - Manual (Page 4)

Advanced Features
Step 2) Press and hold Mode and Set to enter Setup. The
LED will blink red/white/blue
After programming Night Mode, the pump will enter Night Mode at the same time every day until the driver loses power. If the driver loses
power, Night Mode setting must be re-enabled. You can force a pump out of Night Mode by holding both Mode and Set. The pump will
automatically resume Night Mode at the original set time. Once you have forced a pump out of Night Mode, it can not be re-entered manu-
ally and you must wait until the original set time.
Pump Disconnect Calibration
Night Mode
Step 3) Press and hold Mode and Set again to set Night
Mode. The LED will now switch to breathing white.
Step 1) Go into Feed Mode
Step 2) Remove pump from your tank
Step 3) Hold Mode and Set
Step 4) Let the program run
Enter Feed Mode by holding the Mode button for 3 seconds. Feed Mode is indi-
cated by a blinking white light.
Remove the motor and wet side assembly and set aside separately. Motor will still
be running so set it in a safe place with pin spacer facing upwards. (Do not con-
nect both halves of the pump!)
Holding both buttons while in feed mode will change the light from a blinking
white to a cycling white and yellow, this indicates that you have entered Calibra-
tion Mode.
The white and yellow cycling light will continue for about sixty seconds and then
the pump will restart.
Step 5) Re-attach the pump to tank
You have completed the Pump Disconnect Calibration and now have error codes
enabled
Enter the following button sequence to set Night Mode at the precise time when you desire your pump to enter into Night Mode. The
pump’s internal timer will then enter Night Mode for 10 hours and return back to your previous mode for 14 hours.
+
+
hold
+
hold
hold
hold
Remove
Pump
Wait
60sec
Re-attach
Your VorTech can automatically shut down in the event of a pump disconnect. To set-up this mode, you must calibrate
your motor using the following sequence of operations:
Night mode will operate at a constant speed of 50% of the day mode speed.
Reef Crest
Random
Constant
Speed Mode
Short Pulse
Mode
Constant
Speed Mode
Day Mode Night Mode Day Mode Day Mode
80% of
max speed
40% of
max speed
100% of
max speed
50% of
max speed
g g
Example 1 Example 2
Step 1) Wait until the exact time that you wish night mode
to begin.
4