EcoTech Marine Gen 2 MP40 - Manual (Page 6)

During the firmware upgrade process, turn off all Wireless Wave Drivers within 20 feet of the two that
you will be performing the upgrade process with. Also, move the two drivers that you will be using to
upgrade within 3 feet of each other.
Step 1: Prior to powering the unit
on, press and hold the Mode button
and continue to hold mode as you
power on the unit.
Step 2: Continue to hold the Mode
button down while the LED is Red
for approximatley 10 seconds
Step 3: When the LED toggles
between Red and Yellow, the driver
is set as the Upgrade Master driver.
Release the Mode button
On the VorTech Gen2 pump
Once the upgrade process is
started through the Slave Driver,
the Master will flash its LED
quickly in the following colors:
Red, Green, Red, Blue.
On the VorTech Gen1 pump
Step 1: Prior to powering the unit
on, press and hold the Mode and
Set buttons and continue to hold
them as you power the unit on.
Step 2: Continue to hold the Mode
and Set buttons down while the
LED is Red for approximatley 10
seconds.
Step 4: Press and hold the Set
button for approximatley 10 seonds
to start the Firmware Upgrade
process.
Step 5: The process is started
when the LED flashes White and
Blue very quickly. Release the Set
button.
Powered
Off
Powered
Off
Upgrade
Master
Upgrade
Slave
Reciving
New Firmware
Sending
New Firmware
The entire upgrade process takes approximately three minutes. The upgrade is still in progress while the Master driver flashes red, green, red, blue
quickly and the slave driver flashes blue and white quickly. The process is complete when both drivers flash a LED code with half second flashes.
Note: If both WWD’s already have the same firmware revision, the upgrade process will not occur, and the Master will show the Upgrade Completed
Successfully LED code.
The final status of your upgrade can be determined from the LED code on the Master Driver:
Upgrade Completed Successfully: Both Drivers now have the same Firmware.
Upgrade Failed: Communication Error.
Upgrade Failed: The Master Driver’s Firmware is older than the Slave Driver’s Firmware.
The current version of Firmware on your Wireless Wave Driver can be determined when you power it
up by reading the following color combinations:
Bootloader
indicator Major revision
number: Count
each green blink Minor revision number: Count each blue blink Startup com-
plete blink
Firmware Upgrade
Mode Mode
Set
Set
Step 3: When the LED toggles
between Red and White, the driver
is set as the Upgrade Slave driver.
Release both the Mode and Set
buttons.
6