Emerson Radio CKD9918 - Manual (Page 13)

12
Playing Compact Discs
NOTE: This CD player can read CD-R/RW discs, in addition to normal CDs,
however; the compatibility of CD-R/RW discs may be affected by the type of
software that was used to create the discs, as well as the quality and condition
of the blank media you are using. 100% compatibility cannot be guaranteed.
This is not an indication of a problem with the player.
Normal Playback
1.) Press the POWER/ALARM OFF button to switch the unit ‘On’. The
POWER indicator will light.
2.) Press FUNCTION button repeatedly until the "cd" appears in the display.
3.)
4.) Place your disc on the center spindle with the printed label side facing up.
Press down near the center of the disc to make sure it is firmly ‘seated’ on
the spindle, press on the CD door in the area marked OPEN to close the
CD door.
5.) The “ – –” of “cd: – –” flashes while the player
reads the disc. The display will show the total
number of tracks for a few seconds and then
return to the correct time.
NOTE: If the disc is inserted incorrectly, or if
the disc is badly scratched and cannot be
read by the player, “d ISC” will appear on the
display for a few seconds, and then the
display returns to the correct time.
PLAY PLAY
6.) Press the button to begin playback. The
display will briefly show “cd: 01” (Track 1)
and playback on track 1 begins. After a few
seconds the display returns to the correct
time.
To see the track number at any time during
playback press the DISPLAY button. The track
number will appear for several seconds and
then the display returns to the correct time.
Press on the CD door in the area marked
OPEN to open the door.The display will
shows "OP" (open) for 5 seconds, then
change to show clock. If you have not already
done so, remove the ‘dummy CD’ transit
protection card from the CD player and
discard it.