Energenics Kartwash Premier - Manual (Page 2)

KARTWASHER UNLOADING & INSTALLATION INSTRUCTIONS
Your Kartwasher is shipped fully assembled ready to place on the floor or pit in
your selected location. Follow the directions:
Unloading:*DO NOT SIGN BILL OF LADING UNTIL INSPECTED*
1. Unwrap Kartwasher and inspect for damage during shipping.
2. The Kartwasher may be picked up with a forklift with extra long (60” min.)
forks. It must be picked up off center, the weight of the components in the
side of the Kartwasher make it off balance at the center lift. The balance point
which is indicated on the Kartwasher is near the door edge in the middle of
the Kartwasher pallet.
If there is no forklift with extra long forks to pick up the Kartwasher it can be
lifted by any means at one end and dragged off the truck and slid into
position.
3. Lift the Kartwasher and unbolt the wood holding the Kartwasher to the pallet.
Remove the pallet and any plywood under the Kartwasher.
4. Slowly lower the Kartwasher onto the floor. Do not drop. Slide into the final
position using wood between the Kartwasher frame and forks.
5. Mount to the floor in 4-8 places using proper fasteners per floor type.
PIT INSTALLATION (Refer to Drawing 9501-100 or 9501-101)
1. Remove the shipping blocks. Place 4" blocks in one end of the pit.
2. Slide the Kartwasher onto the blocks. Using a “J” bar, forklift or similar
leverage instrument, lower the Kartwasher into the pit. Remove the blocks
from the one end and lower that portion into the pit. Due to the pit dimensions
and depth the Kartwasher must be lowered in stages into the pit. For
conveyor systems see additional instructions.
2