Energenics Kartwash Premier - Manual (Page 4)

START UP INSTRUCTIONS
1. Turn on power at safety switch. In the control panel enclosure manually press
the motor contactor to check direction of the blower motor. If wrong shut off
the power at the safety switch and switch two wires on the bottom of the
contactor. This will change the direction of the blower motor. Do the same
procedure with the pump motor. Both the blower and pump motors are setup
for the proper direction in the factory.
2. Apply compressed air to unit. The clean door should be closed and soil door
should be open. Turn on water to unit and fill reservoir. Make sure ball valve
after pump is in open position. Then prime pump by loosening plug on pump
and pressing motor starter in motor starter box. Load cart in Kartwasher and
press start.
4