Chicago Electric Double Cut Saw 68316 - Manual (Page 12)

Page 12 For technical questions, please call 1-800-444-3353. SKU 68316
Using Lubrication Unit
1. The blades for the Double Cut Saw are
“dry cut” teeth. This mean the blades only
need to be lubricated in extreme cutting
situations, such as when cutting aluminum,
copper, stainless steel and cast iron.
2. To use Lubrication Unit, use cutter paste
that is in rod form which can be inserted
into the center of the Lubrication Unit.
3. Once paste rod is inserted, turn the
Lubrication Unit’s feeder wheel.
Work Piece and Work Area Set Up
1. Wooden work piece selection:
a. Work piece must be free of foreign
objects and loose knots.
b. Do not use to cut logs, tree limbs,
or uneven lumber.
c. Wet lumber, green (unseasoned) lumber,
and pressure treated lumber all have an
increased potential for kickback and should
only be cut with a blade designed for cutting
that lumber. Wear a NIOSH-approved
respirator and have appropriate ventilation
whenever cutting pressure treated lumber.
2. Designate a work area that is clean and well-lit.
The work area must not allow access by children
or pets to prevent distraction and injury.
3. Route the power cord along a safe route
to reach the work area without creating a
tripping hazard or exposing the power cord
to possible damage. The power cord must
reach the work area with enough extra length
to allow free movement while working.
4. Secure loose workpieces using a vise or clamps
(not included) to prevent movement while working.
5. Verify that there are no utility lines or
hardware in or near the workpiece.
This is especially critical for plunge cuts.
SAFETY
OPERA
TION
MAINTENANCE
SETUP