Creda NPP150S 75-773013 User Manual
Page 3
Diagram D
Bracket release for cleaning
For safety, the heater should be switched off at the mains before proceeding. To release
the panel heater from the bracket, the rear catch must be pressed down while pulling the
heater forward gently. It is recommended to use a narrow tool for this purpose. A pencil
or small screwdriver would be a suitable tool. Diagram D shows the procedure for
releasing the heater from the bracket.
When replacing the heater on the bracket, firstly engage the heater on to the bottom hooks
and then press the heater on to the catch. It is recommended to press the heater at the
ends and not to the grille area.
No Controls Models – 75-772901, 75-772902, 75-772903, 75-772904 and 75-772905
These models can be installed in association with a separate room thermostat control.
View of Controls