EVCO EVCSR818P9EF - Manual (Page 19)

EVCO S.p.A. Vcolor 818 | Installer manual ver. 1.1 | Code 144VC818E114
page 19 of 94
5.6 Defrosting activation in manual mode
Operate as follows:
1. Make sure the device is in the "on" status, that pre-cooling or storage cycle is in progress.
2. Make sure that the keyboard is not locked and that no procedure is in progress.
3. Press and release the key (1), press and release the key (2) and then press and release the START/STOP (3)
key.
If the evaporator probe is enabled, i.e. the parameter P4 is set at 1 and on activation of defrosting the evaporator
temperature is above that established with parameter d2, defrosting will not be activated.
5.7 Locking/unlocking of the keyboard
Operate as follows to lock the keyboard:
1. Make sure parameter E8 is set to 1 and no procedures are in progress.
2. Press and release the ON/STAND-BY key (1) and then press the highest interactive key on the left (2).
If parameter E8 is set to 2, on expiry of 60 s the keybord will automatically lock.
Operate as follows to unlock the keyboard:
1. Make sure no procedures are in progress
2. Press and release the ON/STAND-BY key (1) and then press the highest interactive key on the left (2).