Creek Audio T50 - Manual (Page 6)

Store and Pre-sets
M E M O RY
MW LW
FFM M
A M
TIMER
SSTTEER REEO O
kHz
M MH Hzz
Tuning
Pre-sets
M E M O RY
MW LW
FFM M
A M
TIMER
SSTTEER REEO O
kHz
M MH Hzz
Clear Station Memory
To fill the T50’s memory with your favoured stations, select Manual Tuning
by pressing the MODE button and select the desired BAND. Either tune
manually, or use the search UP button to locate the station you wish to
memorise.
Press the STORE button once, briefly. The MEMORY indicator on the
display will flash and the PRE-SET number will be displayed. If you wish
to store the station in this address, press the STORE button firmly and hold
until the MEMORY indicator stops flashing.
If you prefer to allocate the station a different pre-set number (1-29), turn the
tuning knob until the PRE-SET indicator displays the desired number and then
press the STORE button as above. The T50 will now be ready to store
another station and will attempt to place it in the next consecutive pre-set
number address, should you wish to do so. Repeat as necessary to store
your favoured stations in the memory. Return to standard operation by
pressing the MODE button again.
NB. A maximum of 99 stations can be stored in FM, 29 in MW/AM and 6 in
LW (Europe only).
Individual stations can be over-written by selecting the pre-set number with the
TUNING/PRE-SET knob. In order to clear all pre-sets to start again, press and hold
the MODE button until ‘CLEAR’ starts flashing. Then, release and press and hold
the MODE button once more until CLEAR becomes solid. Releasing the MODE
button will blank the display temporarily and clear the memory of all pre-sets.
Note: Any other button press or control knob turn or waiting more than 10 seconds
whilst CLEAR is flashing will cancel the pending program action.