Creek Audio T50 - Manual (Page 7)

7
Nearly every function of the tuner is available via the SRC1 Creek system
remote control handset provided with the T50 tuner, with the exception of
continuous Tuning & Display, which are only available from the front panel.
The six green buttons in the lower section of the handset are dedicated
tuner controls. The functions these buttons provide are:
Store
Band Selection
Mode
Up
Down
Mute
Volume is controlled via the volume up/volume down buttons in the centre
of the handset.
The numeric keys in the top section of the handset are for use only with CD
players and do not apply to the tuner.
The TUNER button is an amplifier input selector and is only used to listen
to the tuner output, like CD or AV. It is not necessary to press TUNER to be
able to control the tuner, only the green buttons should be used.
REMOTE CONTROL OPERATION
Display
The T50 can have four levels of display brightness. The levels are set by pushing the
Display button repeatedly until the desired level is found.
The available levels of brightness are:
1. High (Default)
2. Medium
3. Low
4. Off
The display levels are held in the memory of the T50 and will be remembered if the
tuner is powered off.
If the tuner is working but there is no display, it could be that the display brightness
level has been switched to off.
If any button or the tuning knob is turned, the brightness level will be briefly restored
to setting no.1 and will then revert to the last setting. Remote control is not available
for this function.