EVCO c-pro CLIMA sistema Installer manual - Manual (Page 44)

C-PRO CLIMA SISTEMA INSTALLER MANUAL
Page 44
CANbus (c-pro CLIMA controllers network) and Modbus (towards the RICS supervision system or
other BMS systems).
Entering the ZONES (Zone A / Zone B) menu, it is possible to define the main/construction features
relative to the zones enabled and controlled by the MCZN regulator i.e. the type of terminals
present (radiators or floor plants), the type of sensors installed in the room and their association to
the measurement inputs of the MCZN regulator, the type of regulation to perform in the zone, the
type of dehumidifiers installed (with water line use for dehumidification or not) and the calibration
of the humidity transducer and the remote setpoint variator, if installed in zone.
Entering the DEHUMIDIFYER menu it is possible to enable the presence of the regulator for
additional c-pro micro MCDE dehumidifiers.
Finally the PASSWORDS menu allows to display and modify the 3 password levels present in the
application.
6.5 On/Off pages
Accessing the On/Off pages of the MCZN regulator, it is possible to display the state of the system
(On/Off, to access the next page, press the RIGHT key) and to display and modify the state of Zone
A and Zone B controlled by the regulator, as follows:
Pressing ENTER over ON or OFF, it is possible to modify the state of regulation of Zone A.
Pressing the ENTER key over > access the same setting relative to Zone B.
When the 60 seconds time-out has passed or by pressing ESC, the controller will go back to the
display of the main page.
6.6 System Network page
Accessing the System Network page of the MCZN regulator, it is possible to access the regulator
application for additional MCDE dehumidifiers or go back to the display of the MCCT thermal
power plant regulator as follows:
Pressing ENTER over MCCT access the thermal power plant regulator. Pressing ENTER over
MCDE access the regulator for additional MCDE dehumidifiers connected to the zone. Pressing
ENTER over MCZN remain in the MCZN zone regulator from where access was made.
By pressing ESC key, the controller will go back to the main display of the MCCT thermal power
plant controller.
System state indicator (On/Off)
State of the Zone:
ON = regulation active
OFF = regulation not active
Zone, Name and Number of the MCZN regulator which is
being viewed/changing the state