Carrier Access 5395 Pearl Parkway - Manual (Page 50)

7-2
Events:
Message Explanation
Power Up This is an informational message that logs the time and date
that the stytem was powered up.
Remote Monitor Login/
logout This is an informational message that logs the time and date
that users logged into and off the Remote Monitor software.
Local/Remote switch
change This is an informational message that logs when the Local/
Remote switch on the Access Bank II was changed.
Soft Reset This is an informational message that indicates that the sys-
tem has detected a soft reset
Low Power and/or
Brown-Out conditions This is an alarm message logging information about condi-
tions in which the power dips below standard levels. Note
that when power is cycled off and then on again, the
Access Bank II logs a brownout event. This is a normal
part of operation, and you can ignore these messages.
Alarm Events
Loss of Signal; Signal
Restored The Loss of Signal alarm indicates that the Access Bank II
has stopped receiving the T1 signal. The Signal Restored
message indicates that the signal has been restored follow-
ing a Loss of Signal alarm.
Received Loop Up/
Received Loop Down
Code The Received Loop Up Code message indicates that the
Access Bank II has received an in-band remote loop-up
code. The Received Loop Down Code message indicates
that the Access Bank II has received an in-band remote
loop-down code.
Received Unframed 1’s;
Stopped receiving
Unframed 1’s The Received Unframed 1s message indicates that the
Access Bank II has received unframed ones, and the
Stopped Receiving Unframed 1s message indicates that the
system is no longer receiving unframed ones following a
Received Unframed 1s message.
Loss of Framing; Fram-
ing restored The Loss of Framing message indicates that the system
received unframed data (all ones). The Framing Restored
message indicates that Framing has been restored following
a Loss of Framing error.
received Yellow Alarm;
Yellow Alarm not being
received The Received Yellow Alarm message indicates that the sys-
tem is receiving yellow alarms. The Yellow Alarm Not
Being Received message indicates that the yellow alarm is
no longer being received.