Carrier Access 5395 Pearl Parkway - Manual (Page 14)

1-4
1.4 Connecting the PC Directly to the Access Bank II
The RS-232 Management cable (provided) is equipped with a male 26-pin D-type subminiature
connector on the end that mates with the secondary RS-232 connector pins of the Management port,
and a female 25-pin connector on the DCE end for connection to the RS-232 communications
interface of the PC.
To connect a local PC to the Access Bank II using the RS-232 Management Cable:
1. Set the System Configuration Local/Remote DIP switch 1 on the Access Bank II Control
Panel to the Remote mode.
GND
TXD
RXD
RTS
CTS
DTR
CD
7 GND
14 STXD
16 SRXD
19 SRTS
13 SCTS
10 SDTR
12 SCD
7 GND
2 TX
3 RX
4 RTS
5CTS
20DTR
8CD
BRAID
1 SHIELD 1 SHIELD
RS-232 Management Port
on Access Bank II
D-SUB-26 (male)
SECONDARY
DCE-DB-25
(female)
Local PC with Remote
Monitor Software
CA RRI ER ACC ESS C ORPOR ATION
56 0DQDJHPHQW &DEOH
56 0DQDJHPHQW
3RUW RQ $FFHVV %DQN ,,
&RPP 3RUW RQ
0DQDJHPHQW 3&