Carrier Access 5395 Pearl Parkway - Manual (Page 20)

1-10
The baud rate must be set to match the baud rate of the Access Bank II. The factory default is
9600.
3. DO NOT change any settings in the Access Bank II Port Settings window. These settings are
used only when you are using a modem connection.
1.7.2 Connecting to the Access Bank II
Use the Connection menu to connect to the Access Bank II, and later to perform operations
associated with communications between the Remote Monitor software and the Access Bank II.
1. Attempt to establish a connection.
1. Pull down the Connection menu and click on Connect, or
2. Click on Connect Now, or
3. Click on the connect icon on the toolbar.
Note: If the remote management settings were not made correctly, the connection
will not succeed, and a message will appear telling you to check the serial port and
baud rate settings.