2 analog ports, Analog ports -4 – Carrier Access 5395 Pearl Parkway User Manual
Page 58
8-4
8.2 Analog Ports
The 24 available analog ports are associated with the voice channels and plug-in analog cards of the
Access Bank II. The analog port status is activated upon entering the screen and displays the signal-
ing bits associated with the card type and its signaling type configuration. The Analog Port Status
screen allows the user to monitor the signaling bits in real time as it auto-reads the current status from
the Access Bank II at specified intervals (you must be connected to an Access Bank II).
For each analog card the following data is monitored and described in the table below.
The contents and meaning of the signaling bits depends on the type of signaling used by the circuit
provided over the channel. The Robbed-Bit signaling states for the following types of circuit signal-
ing are provided in the tables below for the D4 (SF) and ESF framing formats. The types are:
•
Loop-Start signaling
•
Ground-Start signaling
Name
Values
Comments
Quiet Channel
0=Off, 1=On
Idle/Active State
Ringback
0=Off, 1=On
Transmit "A"
0, 1
Signaling to network
Transmit "B"
0, 1
Signaling to network
Receive "A"
0, 1
Signaling from network
Receive "B"
0, 1
Signaling from network
Trunk Processing
0=Off, 1=On
Self-test
0=Off, 1=On