Carrier Access 5395 Pearl Parkway - Manual (Page 6)

ii
The Access Bank II Remote Monitor User’s Guide describes how to set up and configure the Access
Bank II for first-time basic operation using the MS Windows 95/98/NT-based Remote Monitor appli-
cation installed on a PC.
The Access Bank II is a family of intelligent T1 voice and data multiplexers, available in the
following models:
• Access Bank II
• Access Bank II SNMP
• Access Bank II SDSL
• Access Bank II SNMP SDSL
• Access Exchange (Access Exchange is not covered in this manual. For
information about using Remote Monitor with Access Exchange, see the Access
Exchange Remote Monitor User’s Guide.)
0.0.1 Access Bank II
The basic model of the Access Bank II provides dual-port T1 voice and data multiplexing, and is
equipped with integrated pairs of Channel Service Units (CSUs) and Data Service Units (DSUs). It
supplies up to 3.072 Mbps of synchronous bandwidth capacity for connecting customer premises
telecommunications equipment to public and private network DS1 services. A V.35 port for internet
or router connections may be configured for up to 1.5 Mbps on one T1, while all 24 voice channels
are terminated on a second T1. A single T1 with a mixture of voice and data can also be used.
0.0.2 Access Bank II SNMP
The Access Bank II SNMP offers all of the features of the Access Bank II, with the following
additional features:
• An embedded Simple Network Management Protocol (SNMP) agent supporting
MIB-II and standard MIBS for T1 and V.35 via TCP/IP over a 10base-T Ethernet
connection.
• A Command Line Interface (CLI) for local or remote management via RS-232 or
telnet connections.