Expert Sleepers Augustus Loop v1.8.0 - Manual (Page 18)

In a more complex example, say the tap times are set to 100%, 75%, 50% and 25%. When
the tape is reversed, the tap times become 100%, 125%, 150% and 175%. Note that the dis-
play of the tap times values does not change, only their internal interpretation.
Because in reverse delay times can reach 200%, you should try to make sure that the
maximum (allocated) delay time is set to at least twice the actual delay time.
Note that the speed at which the tape reverses is controlled by the inertia setting (below).
Stop
Stops the virtual tape.
Note that the speed at which the tape stops, and starts, is controlled by the in-
ertia setting (below).
LFO Speed
Controls the speed of the pitch LFO (in Hz).
LFO Depth
Controls the depth of the pitch LFO.