Expert Sleepers Augustus Loop v1.8.0 - Manual (Page 23)

Trigger Arm
Arms the auto-record trigger.
In this mode the plug-in will watch for an input signal, and when it detects
one it will effectively press 'Tap Rec' on your behalf.
You can adjust the trigger level using the small slider to the left of the input level meter.
The small button below and to the right of the input level meter controls the sensitivity of
the meter. When pressed, the range of the trigger level slider matches that of the meter.
Fade
The auto-fade controls allow you to
smoothly and automatically fade
the loop in and out, effectively turn-
ing the 'Effect' level control for you.
The 'Fade' button activates the fade
operation. Press to fade out; press again to fade back in.
The 'Fade Override' button quickly completes the fade operation, in either direction.
The 'Fade In' and 'Fade Out' knobs set the corresponding fade times, in seconds (up to
30s).
The indicator to the left of the 'Fade' button shows the current level of the fade envelope
(0.0 being fully faded out, 1.0 being fully faded in).
The menu below the indicator allows you to automatically clear the loop (i.e. as if you
pressed the 'Clear Loop' button) when the fade out is complete. There are two settings
(plus 'No Clear'):
• AutoClear - simply activates loop clearing after a fade out.
• AutoClr2 - activates loop clearing after a fade out, then does an instant fade-in after
the loop is clear.
Punch In/Out
These controls are used in conjunction with Tap Re-
cord, and affect the exact time that the start and end
of recording take place. This can be useful when
creating loops in sync with other material playing
in the host application.