Expert Sleepers Silent Way v1.7.3 - Manual (Page 14)

Silent Way DC
Introduction
Silent Way DC is a simple plug-in that generates constant output signals. It is intended to
be used in conjunction with parameter automation (via MIDI or directly by the host appli-
cation) to generate varying signals. For example, you could use it as an LFO where you
draw out the LFO waveform in your host’s parameter automation GUI.
It operates as a stereo or mono plug-in. In stereo mode, the two channels are independent
and have identical controls. In mono mode, the ‘Right Channel’ controls are not used.
NB in Logic, if you’re not passing a signal through the plug-in, you need to load it on an
instrument channel via the ‘AU Instruments’ menu.
Left/Right Channel
There are six knobs per channel.
Out 0->1
Sets the output level between zero and one. This is most useful for generating positive-
only voltages for e.g. gates.
Out -1->1
Sets the output level between minus one and one. This is useful for generating the full
range of negative and positive voltages for controlling e.g. oscillator pitch.