Expert Sleepers Silent Way v1.7.3 - Manual (Page 16)

Silent Way LFO
Introduction
Silent Way LFO, as its name suggests, is intended as a low frequency oscillator, performing
the same functions as LFOs in any other synth e.g. vibrato, filter cut-off modulation, auto-
pan effects etc.
It operates as a stereo or mono plug-in. In stereo mode, the two channels are independent
(except in ‘Quadrature’ mode - see below) and have identical controls. In mono mode, the
‘Right Channel’ controls are not used.
Any input signal to the plug-in is combined into its outputs, according to the setting of the
Input Mode control (see below). It is therefore easy, for example, to apply an LFO to the
pitch CV output of the
Voice Controller plug-in by simply inserting the LFO plug-in on the
same channel as (and after) the Voice Controller. However an input signal is not required,
and the LFO will quite happily do its job without any input connection.
NB in Logic, if you’re not passing a signal through the plug-in, you need to load it on an
instrument channel via the ‘AU Instruments’ menu.