Futaba 6FN - Manual (Page 19)

FACTORY REPAIR SERVICE
To insure prompt service, please follow the instructions given below.
1. Charge the batteries for at least 18 hours prior to shipment.
2. Return the system, only. Not your complete installation. Remove the servos from their mounts and
remove the foam padding from the receiver.
3. Plugs or other modifications which interfere with factory test procedures will be returned to factory
standard at your expense.
4. Carefully pack all components individually, using sufficient packing material to prevent damage
during shipment.
5. Include a brief but thorough explanation of all problems and service required and tape it to the
back of the transmitter. Place a label describing the functions of the servo on each servo.
6. Be sure to include your full address and zip code inside the box as well as on the outside.
7. Include a packing list of all items being returned, and double check to make sure that all items
are packed.
8. Upon receipt of damaged equipment at the FUTABA factory, an estimate of the cost of repair will be
sent to you. Your equipment will then be repaired and returned to you upon receipt of payment.
This factory repair service applies only to the continental U.S.A., Hawaii, and Alaska.