Futaba 6FN - Manual (Page 9)

RECEIVER AND SERVO HANDLING INSTRUCTIONS
1. The FP-R6F receiver employs an 8 bit 1C and has been especially designed for 6 channel use. (Combined 5
channel, 6 channel use.)
2. The block connectors which connect the receiver to each servo form a single unit with the receiver.
3. Connect to the servos by verifying the block connector connection positions stamped on the receiver case. Use
the white relay connector for the ailerons. Be sure to use the 3P white connector from the switch harness for
the power supply (BATT).
XTAL ... Crystal
AUX2 ... For 6CH Tx: Snap switch
AUX1 ... For 6CH Tx: Lever type switch
For 5CH Tx: Snap switch
RUDD ... Rudder (FP-3FN doesn't have rudder)
ELEV ...Elevator
THRO ... Throttle
AILE ... Aileron
8ATT ... Power supply
(FP-3FN doesn't
have rudder)
Fig. 3
RED
FP-R6F
WHITE