Futaba 3PRKA 2.4GHz - Manual (Page 8)

9 Before Operation
POWER
Transmitter T3PRKA-2.4G
Nomenclature / Handling

WARNING
 Do not cover/hold the built-in antenna part
of T3PRKA-2.4G transmitter by your hand
during running.
Do not put any conductive plate/sticker on the
antenna part.
Otherwise, the operating range may become
shorter.

WARNING
 A s w i t h a l l r a d i o f r e q u e n c y
transmissions, the strongest area of
signal transmission is from the sides
of the antenna(built-in). As such, the
antenna(arrow direction) should not be
pointed directly at the model.
Grip Handle
CH3 Switch
Throttle Trigger
Steering Dual Rate Dial (D/R)
Antenna (Built-in)
T h ro t t l e S e r vo
Reversing Switch
Steering Servo
Reversing Switch
Steering Wheel Power Switch
When slid upward,
the power is turned on.
LED Light
It blinks at Low Battery.
Control the speed of the model and movement
forward and backward.
Adjust the steering sensitivity across
the entire range.
The antenna is inside this part.
Steering Trim
Adjusts the steering in small increments so
the model will run straight.
Throttle Trim
Adjusts the throttle in small increments so the
model will not move at neutral.
Front cover
Open the cover by sliding it left until you
hear a "click". Then open it to this side.
T h r o t t l e E n d Po i n t
Adjustment (EPA-CH2)
This function is used to adjust the
forward and brake side servo travel.
Turn model to left or right.