Futaba GY520 - Manual (Page 25)

25
T
AIL
R
OTOR
S
ERVO
I
NSTALLATION AND
S
ETUP
Following your transmitter instructions, program your
transmitter as follows:
❏ Enable the gyro function within the transmitter.
❏ Set the gyro mode to AVCS (GY) within the transmitter.
❏ Set the remote gyro gain to 70% AVCS in the transmitter for
the Normal and Hold fl ight conditions and use 40% AVCS for
all idle up conditions. See “Setting The Gain” section later in
this manual for more details.
❏ Set the Tail Rotor ATV/EPA to 100% for both left and right.
❏ Set D/R to 75% for both left and right. This will reduce the
maximum pirouette rate. Make adjustments to these values
once the initial test fl ight has been completed.
❏ It is recommended that you run 30% softening expo on the tail
rotor channel.
WARNING!
Do not connect the tail rotor servo to the gyro until the servo
type has been selected. Operating the servo using the
incorrect setting may damage the GY520 or the servo.
Once these steps are completed, turn the receiver power on and
allow the gyro to initialize. Follow the instructions within the
“GY520 Programming” section of the manual and select the
Servo Type that matches the servo you have chosen to use. Power
down the receiver for now.
Y520 Mnl.indd 25 Y520 Mnl.indd 25 4/7/2009 7:55:07 AM 4/7/2009 7:55:07 AM