Futaba GY611 - Manual (Page 33)

33
I
NSTALLATION AND
A
DJUSTMENT
2
Connections
Connect the GY611, receiver
and servo as shown below.
Insert the con-
nectors fully and
firmly.
· If a connector works loose
due to vibration during
flight, control may be lost
and result in a dangerous
situation.
· Connect the sensor to the
amp sensor input ("GYRO").
· Connect the rudder servo
to the amp servo output
("SX").
· Connect the amp rudder
input ("RX,1-4") input con-
nector to the receiver rud-
der channel.
Black Red
· Connect the amp remote
gain input ("RX,AUX") con-
nector to the receiver sen-
sitivity setting channel.
To receiver
3
Gyro operation mode selection
When using the gyro only in the NOR mode,
select NOR. When using the gyro only in the
AVCS mode, select AVCS. When using the
gyro in both the AVCS and NOR modes, select
CMT.
(S9256 only)
Always use the special S9256 servo with the GY611.
·The GY611 cannot operate with servos other than the super
narrow pulse (760μs) servo. The servo may be destroyed.