Futaba GY611 - Manual (Page 38)

38
I
NSTALLATION AND
A
DJUSTMENT
(If necessary)
6
When you sense a difference in the rudder effect between the AVCS
and Normal modes, adjust using the GY611 rudder control gain.
· Adjustment method
When the rudder effect in the AVCS is different from the rudder effect
in the Normal mode after adjustment was performed using the trans-
mitter's D/R or AFR function, adjust the difference using the NCGx
parameter.
7
Adjust the left and right pirouette stopping state by control delay and
tracking.
· Adjustment using the delay function of the T14MZ and T9Z transmit-
ter is also possible. Since the gyro gain also has a large effect on the
stopping state, make this adjustment after adjusting the sensitivity.
Point (ATV) amount of the transmitter sensitivity setting channel. The actual
sensitivity can be checked on the GY611 normal screen display.
5
Adjust the hovering and flight rudder effect using the transmitter's
D/R or AFR function.
· Do not adjust with the End Point (ATV) function. If the End Point (ATV) func-
tion is used, trimming may change.