Daily living – CHEVROLET Roadtrek User Manual
Page 19
DAILY LIVING
D
Do
occ N
No
o:: 21906532-210C05 R
Re
ev
v:: 02
C
Co
op
py
yrriig
gh
htt ©
© H
Ha
an
nm
ma
arr M
Mo
otto
orr C
Co
orrp
po
orra
attiio
on
n 2
20
00
05
5
B
B--5
5
REAR KING BED / REAR QUEEN BED
REAR KING SIZE BED (Popular Model)/
REAR QUEEN SIZE BED (Versatile Model):
To convert the dinette into a King size bed
or Queen size bed :
1.
Remove the table and leg from its receptacle.
2.
Remove night table and store. In order to remove,
unscrew the wing nut found on each side of the
night table, (see Picture B-P7). Store wing nut in
the night tables drawer when not in use.
3.
Place table top in storage, (see Picture B-P6).
4.
Remove bed support from storage located under
bed base on passenger side, (see Picture B-P9).
5.
Install bed support, (see Picture B-P10).
6.
Slide both bottom cushions together so that they
meet in the middle, (see Picture BP-11).
7.
Place both back rest cushions on sides,
(see Picture B-P12). NOTE: The longer back rest
cushion must be placed on the driver side to
provide clearance for the bathroom door.
8.
Push down the back rest cushions so they lay flat
to create the King size or Queen size bed.
9.
Install filler cushions, (see Pictures B-P12 & 13).
To convert back to a dinette, perform these steps in
reverse order.
Picture B-P13: Placement of filler cushion.
Picture B-P12: Placement of back rest cushions.
Picture B-P10: Placement of support for bed.
Picture B-P11: Lay cushions flat.