Daily living, Toilet, Stand-up aisle shower – CHEVROLET Roadtrek User Manual
Page 22
DAILY LIVING
D
Do
occ N
No
o:: 21906532-210C05 R
Re
ev
v:: 02
C
Co
op
py
yrriig
gh
htt ©
© H
Ha
an
nm
ma
arr M
Mo
otto
orr C
Co
orrp
po
orra
attiio
on
n 2
20
00
05
5
B
B--8
8
WASHROOM FACILITIES:
TOILET:
1.
Privacy is achieved by extending all privacy doors
and closing the galley curtain.
2.
The washroom is equipped with an automatic light
that will illuminate when the door is in the open
position, (see Picture B-P20).
STAND-UP AISLE SHOWER:
To set up the stand-up aisle shower:
1.
Remove floor drain cover and drain plug from floor,
(see Picture P-B21).
2.
Privacy is achieved by extending all privacy doors
and closing the galley curtain.
3.
Release the Velcro retention straps and move the
hand held shower from its storage position to
shower position, (see Picture B-P22).
4.
Draw the shower curtain until you are completely
surrounded.
5.
Using the Velcro connectors, secure the edges of the
curtain together allowing the shower hose to hang
within the shower area to retain any dripping water.
6.
When adjusting the water temperature, be sure to
allow enough time for the temperature adjusted
water to exit the shower head before making further
adjustments.
7.
Roof vent may be used on low speed to remove
steam and moisture.
Note: To conserve water, discontinue the water flow
at the shower head between wetting and rinsing.
To put away the stand-up shower:
1.
Rinse and dry the shower curtain thoroughly,
(this function is most easily performed before
leaving the shower area after use).
2.
Allow the curtain to air dry completely, (this function
can be expedited using the power roof vent).
3.
Replace drain plug and floor drain cover when
finished.
To prevent grey water tank contents from spilling onto the floor
while driving,keep the drain plug secured when not in use.
Picture B-P22: Hand held shower head in its shower
position.
Picture B-P21: Floor drain, remove floor drain cover
using the access holes provided in the cover.
Picture B-P20:
Light activation
switch located at
floor level.
Floor Drain Cover