Panel descriptions control panel, Rear panel – Roland CK-100 User Manual
Page 3
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
PANEL DESCRIPTIONS
Control Panel
EQUALIZER
INDICATOR
INPUT JACKS 1. 2
These jacks are to feed the signal from
the keyboards. By controlling the Volume
Knob 1 and 2, you can mix two input
signals at any proportion you like.
VOLUME 1,2
With the Volume Knobs, individual volume
control is possible. When the input signal
is too high, pull the knob to instantly
attenuate the level. (—15dB)
EQUALIZER
This section controls the tone of the
bass, middle and treble. At the center
position, the flat characteristic is obtained.
Rear Panel
MAIN-IN JACK HEADPHONES JACK
EFFECT JACKS
PRE-OUT JACK
MAIN-IN JACK
These jacks can be effectively used to
connect various effect units such as a
delay machine, reverb, etc. Connect the
Pre-Out to the Input of the effect unit,
and connect the Output of the effect
unit to the Main-ln.
* Connecting the Main In Jack to the
Line-Out (or Pre-Out) of the other key
board amplifier or PA/audio. the CK-100
will serve as a subordinate amplifier or
monitor amplifier. (In this case, however,
the knobs on the control panel does not
work.)
LINE-OUT JACK
This jack can be used for recording,
setting up with a second amplifier or
feeding the PA. etc.
* An effect unit cannot be set up between
the Line-Out and Main-In jacks.