FXpansion Maul - Manual (Page 27)

TransMod modulation 27
© 2012 FXpansion Audio
3.3.2 Envelope Follower
Maul's envelope follower reacts to the amplitude of the input signal
to create a series of attack-decay envelopes which are used as
modulation signals in the TransMod system. Try using the Follower
source to modulate the filter C utoff and Drive parameters in the
distortion stages.
The Envelope Follower module's Visualizer represents the real-time
output of the module.
Attack
This control sets the Attack time of the envelope generated in
response to a new detected transient.
Decay
This control sets the Decay time of the generated envelope.
Level
The Level control allows you to attenuate the level of the signal entering the envelope follower
transient detection circuit. At 100%, no attenuation is applied on the signal.
Gain
The Gain control offers a final attenuation control for the output of the module before it enters the
TransMod modulation system. At 100%, no attenuation is applied to the output modulation signal.
This control is intended to be modulated by other TransMod sources, in a similar way to using a
VC A to scale one modulation source with another in an analogue modular system.