Cobra Electronics CXR725 - Manual (Page 13)

Customer Assistance Warranty Introduction
21
Operation
20
Operation
Memory Location Scan
•
Your microTALK radio can automatically scan up to
10 programmed
Memory Locations.
If there are one or fewer memory locations programmed
in your radio, the scan memory locations option will not be
available. To program at least two memory locations, see
program memory locations on page 13.
To scan memory locations:
1. Press the Mode button until the Scan icon,
Memory icon and the memory location number
flash on the display.
2. Press the Channel Up or Channel Down
button to begin scanning memory locations.
The Scan icon and the Memory icon will continue
to be displayed when memory
location scan is
on. Your radio will continue
to scan memory locations and stop if an incoming
transmission is detected. Your
radio will remain on that memory location
for 10 seconds.
While setting memory location scan, if you do not press any buttons for
15 seconds, your radio will automatically return to
Standby mode on
the channel/privacy code displayed before you entered mode functions.
During privacy code scan (while receiving an incoming
transmission), you can choose from the following:
a. Press and hold the Talk button to communicate on that
channel/privacy code. Your radio will remain on
that channel/privacy code and return to
Standby mode.
b. Press the Channel Up or Channel Down button to resume
scanning privacy codes.
If you press the Talk button while scanning, but more than 10 seconds
after receiving a transmission, you will transmit on the channel/privacy
code on which you last received a transmission. This will then return the
radio to
Standby mode.
If you do not press any button within 10 seconds, your radio will
automatically resume scanning privacy codes.
During privacy code scan (while not receiving a transmission),
you can choose from the following:
a. Press and hold the Talk button to communicate on
the channel/privacy code that was displayed before you entered
mode functions or the channel/privacy code on which, during
scanning, you last received a transmission. This will return the
radio to
Standby mode.
b. Press the Mode button to proceed to set memory location scan
(see page 21 for further details).
c. Press the Lock/Enter button to return to Standby mode on the
channel/privacy code that was displayed before you entered mode
functions or the channel/privacy code on which, during scanning,
you last received a transmission.
Mode Functions
Mode Button
Channel Buttons
Scanning Locations
Nothing Comes Close to a Cobra ®