Cabletron Systems 2E48-27R - Manual (Page 94)

Chapter 5: Local Management
5-48 2E48-27R/2E49-27R User’s Guide
Flash Memory Installed (Read-only)
Indicates the amount of FLASH memory installed in the 2E4X-27R and
how much is currently available.
DRAM Installed (Read-only)
Indicates the amount of DRAM installed in the 2E4X-27R and how much
of it is currently available.
NVRAM Installed (Read-only)
Indicates the amount of NVRAM installed in the 2E4X-27R and how
much of it is currently available.
Current Switch Utilization (Read-only)
Shows the percentage of the device switching capacity currently being
used.
Peak Switch Utilization (Read-only)
Shows the peak percentage of device switching capacity used, since the
last reset.
Reset Peak Switch Utilization (Toggle)
Allows the user to reset the Peak Switch Utilization field. The switch may
be set to either YES or NO as described in
Section 5.13.1 . YES resets the
Peak Switch Utilization field to the current system traffic.
5.13.1 Setting the Reset Peak Switch Utilization
To set the Reset Peak Switch Utilization field to YES or NO, proceed as
follows:
1. Use the arrow keys to highlight the Reset Peak Switch Utilization
field.
2. Press the SPACE bar to select YES or NO.
3. Use the arrow keys to highlight the SAVE command at the bottom of
the screen.
4. Press ENTER. The message “SAVED OK” displays.