Graph Tech Ghost - Manual (Page 32)

32
For mounting the Hexpander output on the edge
of the instrument, the small PC board with the 13-
pin jack requires a rectangular mounting hole in the
body. Choose a location for this hole, checking that
there is room for a 1-1/8” (30mm) deep cavity, and
that the ribbon cable will reach from here to the main
Hexpander board. The size and placement of this hole
can be determined using the template in this guide.
Cut out this template and tape it to your guitar where you want
the jack. Follow the 13-pin jack installation instructions
to scribe marks through the template to locate the hole.
Hexpander
13-pin jack