Graph Tech Ghost User Manual
Page 57
57
Acousti-phonic
GHST
VOL
MAG
Bk
Gn
Mag pickups
Mag Volume
Piezo Volume
250k or 500k
audio taper
Bk
Y
Vi
To convert your tone control to an acoustic volume control, begin
by unsoldering and removing any wires or components attached
to the tone pot. Solder the purple, yellow, and black wires to the
pot according to the diagram. Plug the acoustic volume harness
into the Acousti-Phonic so that it spans the pin rows labeled
GST VOL MAG (G V M when the Hexpander is piggybacked on
the Acousti-Phonic) with the purple, yellow, and green wires
nearest the labels and the ground wire furthest from the labels.
The green wire is the input from your magnetic pickups; solder
it to the middle lug of your magnetic volume pot. Remove the
wire that runs from your 1/4” jack to the magnetic pickup system.