Great Planes Evader EDF Sport Jet EP ARF - GPMA1800 - Manual (Page 20)

20
Assemble the Bungee Launch
❏
1. Loop one end of the rubber tubing and insert it through
one of the metal rings.
❏
2. Bend the loop down around the ring. Then pull the ring
the rest of the way through the loop.
❏
3. Pull the tubing to tighten the knot and make sure it is
secure.
Now attach the cord…
❏
4. Loop one end of the cord through the ring.
❏
5. Bring the loop in back over itself and the ring. You’ll
have to pull the rest of the cord up all the way through the
loop before tightening it around the ring.
❏
6. Pull tightly on the tubing and the cord to make sure it is
secure. Add a drop of thin or medium CA to the knot in the
cord over the ring.
❏
7. Secure the end of the tubing to the ring with one of the
included small nylon ties.
❏
8. Attach the other end of the tubing to the stake and the
other end of the cord to the other ring. Add another nylon tie
to the end of the tubing at the stake as well.
❏
9. Now the bungee is ready to use. Wind it back up onto
the plywood holder.